Deck Grip - Clear Indoor & Outdoor Non-Slip Sealer for Concrete

S-CT-DECKGRP1GK

SlipDoctors

  • $145.00


Deck Grip is an anti-slip sealer for concrete and other stone surfaces. This versatile non-slip coating is non-yellowing, water-based acrylic and is easy to apply. Deck Grip non-slip concrete results in a clear, semi-gloss and barefoot-friendly finish that is chemical resistant, UV resistant and highly durable. Deck Grip is the perfect anti-slip solution to treat slippery pool decks, and all types of stamped (sealed or unsealed) concrete decks.  Compatible on virtually all types of natural stone surfaces where anti-slip sealers are desired.

Deck Grip Roller - Click here to buy more

Sealed Stamped Concrete - Deck Grip will work great on top of all sealers and is chemical and chlorine resistant.  Ideas for surfaces surrounding pools and spas.  Please start with a clean dry surface prior to application.  Allow 24 hours to cure.  Apply 2 thin coats for best durability and slip resistance.  NOTE:  Some textured surfaces require 3 coats for best traction.

Even when wet, your slippery floor’s slip resistance after the non-slip solution will surpass ANSI A137.1, A326.3 or B101.3 standards.

0.52 Wet DCOF - ANSI B101.3
0.53 Wet DCOF – ANSI A137.1 / A326.3
0.62 Wet SCOF - ANSI B101.1

Installation Instructions (TDS) Safety Data Sheet (SDS)
  • Great for bare feet
  • Use it on pool decks and sealed concrete
  • One 3/8” nap roller included per gallon
  • Deck Grip is available in 1 gallon and 5-gallon pails
  • Can be used indoors or outdoors
  • It dries clear with a semi-gloss finish and is easy to apply
  • One gallon covers 300 – 600 square feet
  • Roller Included (Click here to buy more)



Gallon 5-Gallon
Coverage per Sq Ft 300-600 Appx 2,500
Cost per Sq Ft (Appx.) $0.25 $0.23
⅜” Nap Rollers Included 1 5
Volume (liters) 3.78 18.92


Safety Precautions:
• Use in a well-ventilated area.
• If you scrape, sand or remove old paint from any surface, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Hotline at 1-800-424-LEAD or www.epa.gov/leadfor more information.

Optional Safety Equipment:
• Chemical-resistant gloves
• Eye protection
• Mask

Surface Preparation:
• Surface preparation varies by surface. Please see chart below for specific surface preparation instructions.

Application Instructions:

Step 1: Mixing Additive: The quantity of SlipDoctors Deck Grip Additive to be used depends on the level of slip resistance desired(see chart below). Maximum texture is recommended for the most effective anti-slip protection. Pour desired amount of Additive into Deck Grip container and gently mix to ensure even distribution. Avoid shaking to prevent foaming. Mix occasionally during application.



Step 2: TEST: Deck Grip should be tested on a small inconspicuous area before full application

Step 3: Deck Grip can be rolled or sprayed, rolling is recommended. Roll: Use the included3/8” nap roller to evenly coat the surface. Avoid puddling in low areas. If puddles occur, roll them out. Two thin coats are recommended rather than one thick coat. Spray: Spray using a 5916 nozzle that produces a flow of 1/10 of one gallon per minute. Spray in a fine fog pattern without spurts or dribbles to form a thin continuous film. Avoid puddling in low areas. If puddles occur, roll them out.

Step 4: For added protection, greater performance and durability,we recommend applying Deck Gripin two thin coats. Allow first coat to dry for 2-4hours before applying the second coat. The second coat should be applied at a right angle to the first coat.

Step 5: Clean-up:While Deck Gripis still wet, equipment may be cleaned with soap and water. Once dried, equipment may be cleaned with a solvent, such as xylene or toluene.

Maintenance:
For general cleaning and maintenance,use a light pressure rinsing. For best results to remove oily deposits or other foreign matter, apply pH-neutral cleanerat recommended dilution rate and scrub lightly with a soft bristle deck brush.Do not use alcohol-based cleaners, such as pine-sol.

Customer Reviews

Based on 70 reviews
84%
(59)
11%
(8)
3%
(2)
1%
(1)
0%
(0)
D
DARREN H.
YAY, NO MORE SLIPPING

We laid Mexican style tiles on our sloped front path, looks great but we soon found out not very practical on wet days,I was placing a barricade just to deter any visitors from using the path out of fear of any nasty accidents. I came across Slip Doctors and decided to purchase a couple of bottles of Deck Grip and what a difference the product made. No more slipping, we’ve had quite a few wet days recently and I made a purpose of walking up and down the wet path in Cowboy boots and then a pair of thongs ( you guys call em Flip Flops ) with no worries at all. Easy application and clean up. As I said I purcahased 2 bottles to do front and back but I didn’t need to open the second one. Fast shipping to Australia too.

b
bill r.
quick efficient

the sales team is extremely helpful and follow through with responses to questions.

V
Vickie S.

I received my order, 2 packages of rollers,2 gallons of sealer but only 1 jar offer
Deck grip anti-slip additive, I need one more could you please send that then we will be able to apply it to our slippery sidewalk and I will let you know how well it works ! Thanks

D
Dean S.W.
good

hi guys

Thank you for purchasing our product. Team SlipDoctors


Customers Who Purchased This Item Also Viewed


Sale

Unavailable

Sold Out