Non-Slip Pre-Cut Stair Treads – 6” x 24” – 80 Grit, Black Adhesive Backing
Non-Slip Pre-Cut Stair Treads – 6” x 24” – 80 Grit, Black Adhesive Backing
Non-Slip Pre-Cut Stair Treads – 6” x 24” – 80 Grit, Black Adhesive Backing
Non-Slip Pre-Cut Stair Treads – 6” x 24” – 80 Grit, Black Adhesive Backing
Non-Slip Pre-Cut Stair Treads – 6” x 24” – 80 Grit, Black Adhesive Backing
Non-Slip Pre-Cut Stair Treads – 6” x 24” – 80 Grit, Black Adhesive Backing

Non-Slip Pre-Cut Stair Treads – 6” x 24” – 80 Grit, Black Adhesive Backing

$20.00

BULK DISCOUNTS AVAILABLE

/
Options
  • For maximum protection against slips and falls, our 80-grit coarse texture stair treads are made of a durable aluminum oxide formulation that is long lasting and resistant to weather, water, and chemicals.
  • Ideal for use on metal, sealed wood, and sealed concrete.
  • Easy to apply with a strong adhesive backing and abrasive non-slip texture.
  • Tread Size: 6” x 24”.
  • Available in singles, 5-pack, 10-pack and 25-pack.

When it comes to steps and stairs, you have to make sure these surfaces are safeguarded to avoid slips and falls. SlipDoctors specializes in non-slip stair treads that are ideal for preventing devastating slip-and-fall accidents.

These stair treads adhesive are great for basements, warehouse docks, loading docks, and patio steps. They are designed to be weather resistant to both heat and rain and can be used for both indoor and outdoor construction sites, hazardous areas, and other slippery environments.

The anti-slip stair treads peel and stick strips come pre-cut into 6″ x 24″ treads. This size makes them ideal for use on most steps and stairs. The non-slip step treads come with a roller that allows you to apply them fast and efficiently.

NOTES
  • Videos are available to illustrate basic application instructions.
SURFACE PREPARATION
  • Keep the material in a dry, warm environment in its original protective packaging until ready to apply.
  • Surface must be clean, dry, and free of surface contaminants. Clean surface with Isopropyl Alcohol (IPA) cleaner to remove surface dirt and residues.
  • Porous surfaces must be sealed prior to application to prevent moisture from interfering with adhesion.
APPLICATION
  • Decide on placement before removing adhesive.
  • Peel back part of the release liner. Press the adhesive firmly onto the prepared surface.
  • Slowly keep peeling back the liner while applying the tape to the surface. Do not stretch or pull the tread too tightly.
  • Once applied, press tape down firmly using even pressure with a seam roller.
  • The adhesive will be fully cured in 48 hours.