Clear Acrylic Paint Primer for Interior & Exterior Floors

• Primer Clear is a premium high-performance, water-based acrylic primer for indoor and outdoor applications.
• Primer Clear acts as a barrier coat to allow most clear, water-based coatings to be applied without absorbing into porous surfaces.
• Recommended for use with SlipDoctors water-based coatings.

• Up to 250 sq. ft per gallon

Tired of battling with dusty and porous substrates when applying coatings to your floors? Look no further – SlipDoctors presents an innovative solution with our Acrylic Waterborne Primer. Perfect for addressing weak floor adhesion, this primer is your key to ensuring optimal adhesion for any water-based paints and coatings.

A robust connection between your surface and the coating is paramount for achieving a durable finish, consistent color, and a seamlessly smooth surface. Weak adhesion poses a risk of inadequate coverage, resulting in uneven surfaces and floors prone to premature corrosion. Our clear waterborne primer is meticulously crafted to seal out moisture and fortify the bond between the substrate and the paint or coating.

Discover the versatility of SlipDoctors' Acrylic Waterborne Primer, offering an ideal solution for weak floor adhesion on both interior and exterior surfaces. Unlike some primers that alter the original appearance of your floors, ours is engineered to preserve the natural look and feel of various surfaces. Suitable for a wide range of floors, including: Concrete, painted concrete, wood, fiberglass, tile surfaces, aluminum or metal.

Ideally used with Tuff Grip Clear and Alpha Grip non-slip floor paints.

• Use in a well-ventilated area.
• If you scrape, sand, or remove old paint from any surface, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Hotline at 1-800-424-LEAD or www.epa.gov/lead.

• Surface must be clean, and free of dust, grease, wax, soap residue, peeling paint, mold, and mildew.
• Solvent wipe and/or detergent clean surfaces before application.
• Sandblast or wire-brush surfaces to remove rust, mill scale, or other hard-to-remove contaminants.
• Surface should be thoroughly degreased.

• Step 1: Always test a small area before full application.
• Step 2: Use a drill mixer or hand stir to thoroughly mix Primer Clear before applying. Stir occasionally during use. No thinning is required.
• Step 3: Apply with a 3/8” nap roller or spray with a paint gun or air sprayer. For the best results, one thin coat is recommended. The coating may be applied after 30-60 minutes or when tacky.
• Step 4: CLEAN UP: While wet, equipment may be cleaned with soap and water. Once dried, equipment may be cleaned with a solvent such as xylene.